TM 11-5820-890-30-4
14-26. REPLACEMENT OF TERMINAL LUG.
Tools:
Cross tip screwdriver
Soldering kit
Long nose pliers
Expendable Supplies:
Solder
Alcohol
Cotton swabs
References:
Paragraph 14-19 for removal and installation of mounting plate.
ITEM
ACTION
REMARKS
REMOVAL
a. Mounting plate
b. Terminal lug (3) wire
c. Screw, flat washer, and
Iockwasher
d. Terminal lug (3)
INSTALLATION
e. Terminal lug (3)
f. Screw, flat washer, and
Iockwasher
g. Terminal lug (3) wire
h. Mounting plate
Remove and retain.
Tag the wire. Use long nose pliers and
soldering kit. Desolder tagged wire from
terminal lug. See figure 14-6.
Use cross tip screwdriver. Remove and
inspect screw, flat washer, and lock-
washer securing terminal lug (3) to
chassis. If damaged, obtain replacement.
Remove and discard.
Obtain replacement terminal lug.
Use cross tip screwdriver. Install retain-
ed screw, flat washer, and Iockwasher
securing terminal lug (3) to chassis.
Use long nose pliers and soldering kit.
Attach and solder tagged wire to termi-
nal lug, and remove wire tags.
Install retained mounting plate on battery
tray subassembly.
Refer to paragraph 14-19
for removal of mounting
plate.
These were removed in
step c.
Before and after soldering,
clean wires and terminal
lugs with alcohol and cotton
swabs.
Refer to paragraph 14-19
for installation of mounting
plate.
14-29
