TM 11-5820-890-30-4
14-27
Tools:
REPLACEMENT OF WIRES.
Cross tip screwdriver
Soldering kit
Diagonal cutting pliers
Long nose pliers
Wire strippers
Expendable Supplies:
Solder
Cotton swabs
Tiedown straps
Alcohol
Connectors
Wire
References:
Paragraph 14-19 for removal and installation of mounting plate assembly.
Paragraph 14-24 for removal and installation of J1 connector.
ITEM
ACTION
REMARKS
REMOVAL
a. Mounting plate
b. Wire(s) (2) and tiedown
strap(s) (1)
c. Wire(s) (2)
INSTALLATION
d. Wires(s) (2) and tiedown
strap(s) (1)
Remove and retain.
Refer to paragraph 14-19
for removal of mounting
plate.
Use long nose pliers and soldering kit.
If J1 connector wires are
Desolder both ends of defective wire(s)
involved, refer to paragraph
to be replaced. Cut, remove, and dis-
14-24 for removal of J1
card tiedown strap(s) along wire(s).
connector.
See figure 14-6.
Remove and discard defective wire(s).
Obtain replacement wire(s) and tiedown
strap(s). Using wire strippers, remove
insulation from ends of replacement wire(s).
Figure. 14-6. Battery Tray Subassembly With Internal Wiring Harness.
14-30
